Waxing the floor can decontaminate the glaze, increase the appearance, prevent insects, moisture, cracks and extend the life of the floor. It is a necessary measure for the maintenance of the floor, but if the method is improper, the white will be generated when the floor is waxed. The phenomenon of ring marks, discoloration, etc. is counterproductive, so be sure to pay attention to the following items when waxing the floor.

If the waxing method is improper, it will produce whitening, ring marks, and discoloration. Be sure to read the following precautions when servicing the floor waxing.

1. Choose sunny weather waxing

If the humidity is too high in rainy days, waxing will cause white turbidity.

When the room temperature is below 5 degrees, the floor wax will become hard.

Do not use a rag containing chemicals to clean the floor before waxing, which may result in poor adhesion of the floor wax.

2. Remove rubbish and dirt from the floor surface.

Use a vacuum cleaner to remove dirt and dust from the floor surface.

Wipe the stains on the floor with a diluted neutral detergent.

Wipes that are difficult to remove can be wiped with water.

To prevent the detergent from accumulating in the grooves, the rag soaked with detergent should be wrung out as much as possible.

Floor wax removers can cause visible stains and bulging on the floor and must never be used.

3. Wipe with a wrung rag.

Wipe with a rag that has been wrung out.

The surface of the floor, especially the grooved part, should be carefully wiped and no detergent remains.

If the detergent and moisture are left behind, it will cause whitening and swelling.

4. Fully dry

The moisture on the floor surface and the groove portion is completely dried to be waxed at the rear. Depending on the season, the time required varies, but it takes about half a day. If it is not fully dried, the floor wax will not adhere to the surface of the floor, affecting the appearance and causing whitening.

5. Waxing method

Shake the container with the floor wax and mix well. Before the entire floor of the room is waxed, it is necessary to perform a partial trial at the corner of the room, etc., to confirm whether there is any abnormality. In order to prevent the floor wax from polluting the wall skirting and furniture, cover the above parts with tape paper. Use a clean rag to fully dip the floor wax, so it is better to not drip. Do not pour the floor wax directly onto the floor, otherwise it will produce traces and loop marks. Carefully apply according to the grain direction of the floor, do not leak or thick and uneven. If the amount of application is too small, unevenness will result, and too much application will result in poor film formation. Keeping it thin and even is the key to waxing. Do not dilute the floor wax with water. The waxing tool can be used with a special mop for waxing, which is easy to operate and has an ideal effect.

6. Do not walk on the floor before the floor wax is dry.

Drying usually takes 20 minutes to 1 hour. If there is a leak, apply it. If it is used twice, the second time, after the first complete drying. Once every 6 months, you can keep the floor beautifully for a long time.

Wooden floor waxing precautions

1. Select the corresponding floor wax according to the type of floor. Floor wax can be roughly divided into water and oil.

2. Method for removing floor wax

Some of the common floor wax removers are strongly alkaline. Because the material of the wooden floor is wood and alkaline components, the floor will be discolored and stained, and it will never be used. A method of wiping with a rag dipping solvent (urea hydride water) can be used.

3. Precautions when laying the floor

The bonding strength of urea-formaldehyde binders is high and special care must be taken. After adhering to the surface, place a rag soaked in urea-formaldehyde water, and cover the plastic film with a rag, soften the adhesive, and then remove it with a bamboo blade or plastic blade.

4. Required tools and materials

Resin floor wax, cover tape, special wax for waxing, solvent (urea aldehyde water), bucket, solvent resistant gloves, rag, plastic blade, bamboo blade, vacuum cleaner.

Fiberglass Tape Measure

Fiberglass Tape Measure,Tape Line Measure,Magnet Tape Measure,Abs Fiberglass Tape Measure

Shangqiu Hengli Measuring Tools Co.,Ltd , https://www.henglimtools.com