1. Clean the floor first.

2. Make sure the floor is dry.

3. Apply a layer of bitumen oil layer. Asphalt oil is sold on the market and there is no need to use bitumen blocks for melting. The reason for this is to prevent moisture and insects.

4. Playing floor: generally use 9% plywood, others use 12%. The 9-centimeter plate must be cut into four pieces, with a gap of one centimeter between each piece. Then use steel nails to secure the board to the ground.

5. Laying log flooring. With nails on the four sides of the board, note that only two small dots of white latex can be used on each board. Because white latex is water-based, too much moisture will cause the wood to arch.

6. Polish the floor. At least three times. The second time the polished wood powder should be retained.

7. Fill the gap between the planks with the remaining wood dust.

8. On the wooden floor oil. At least three times.