Each tile is very firm and flat. The aluminum alloy ceiling directly rests on the tile that has just been laid, and it is easy to loosen the tile. The tiles in the entire bathroom are the same in color and seamless, with no disproportionate “patchâ€. Due to the loss of two tiles, two striking "patches" appeared on the corners of the wall, making it difficult to see. The surface of the tile is clean, with no stains or anything, and it can be seen that the construction of the worker is very serious. Workers are not serious when constructing, mud flows out on the surface of the tile, and it is difficult to clean. The red tiles are beautifully laid and the whole looks very comfortable. Two tiles were missing on the ledge, probably due to the loss of tiles, and workers promised to make up for it. Use a small hammer to gently tap the tile surface to check if each tile is empty. Test yourself by tapping the surface of the brick wall yourself. If the sound of the tapping sound is heavy, it means there is no empty drum; If the sound is "abrupt" and hard, it means that the wall is empty. The gap between the tiles is fine and uniform, and the circumference between the tiles and the tiles is straight. Tile caulking did not do a good job, uneven gaps, not beautiful. This is the place where cracks are most likely to occur, but the worker is doing well and the tiles are crack-free. At first glance is the rough construction, the tile surface has been damaged and should be reworked. The wall on the side of the window sill is narrow and the width is just the same as the tile width, so there is no non-complete brick. Due to the width problem, this wall uses a row of cut tiles, but the width of the tiles is less than one third of the original brick. The mosaics in the bathroom are tiled, and the edges of the yin and yang corners are neat and tightly combined with an error of only 0.8 mm. The tile tiles around the window sill, the yin and yang angles roughly meet the quality requirements, with a deviation of about 2.8 mm. The mirror is embedded on the wall and is rimmed for safety. One of the mirrors next to the dining table is inlaid directly, and the perimeter is particularly smooth with no burrs. The balcony floor tile is more difficult to paved, but the workers are extremely careful and firm. The floor tiles in the living room are well paved, and it is very practical to step on them without loose feeling. Careful workers scrub the tiles, not only clean, but also particularly smooth. Dust has accumulated in the cracks in the tile, throwing messy things on it and not picking it up. How can people not feel bad? The color and model of the floor tiles in the bathroom are exactly the same, and they are fully qualified after the inspection. There are no tiles on the corners of the balcony, and a large amount of soil particles accumulate there. It is unsanitary. Tiles are laid carefully and the floor tiles are evenly spaced. Although the floor tiles of the balcony are larger than the living room, they are fairly even. Each tile is quite complete and there are no missing surfaces. When the new house was handed over, it was found that there were two broken blue tiles on the bathroom steps. The open space around the floor tiles is reserved according to the design drawings. The edges are neat and the width is the same. The width of the floor tiles is obviously inconsistent. It is hard to see and filth. Use a small hammer to tap the tile to see if there is any empty drum sound. The owner can use his hand to tap the floor tiles to check for empty drums. If the sound is heavy, there should be no empty drums. This slope is designed according to the drainage design. According to requirements, the connection between the floor tile and the floor drain is very close and firm. The floor drain joint is tight and firm, but the floor drain is full of dust, and there is a broken wire, so that it is not strange to use Jinshan. Blue and white tiles in the kitchen are beautifully laid out, and the flatness is almost error-free. The installation of the shower room requires that the tiles must be laid flat, otherwise the shower room may not be even. Bricks were chosen seamlessly, and they were particularly well paved and exaggerated. Technically, they were basically seamless. The seams of the floor tiles are too large to be really impatient. After measuring, it was found that the width of the seams was 2.5mm, which greatly exceeded the standard. The marble door bar in the bathroom plays a significant role in waterproofing. Care must be taken during construction to ensure that the joints with the tiles are smooth and tight. The construction of irresponsible workers and sloppy marble countertops on the window sill makes the owner feel bad. The marble material is relatively hard, and it is best to use plastic film or newspapers after the completion of construction to ensure that the table is clean and not damaged. There was debris on the marble countertops, and the paint bucket was placed on it. If the paint accidentally touched the white marble, it was difficult to scrub. Floor Acceptance Marble Window Paint Bathroom New Home Living Room Wall Color Marble Tiles Marble Dining Table Kitchen Wall Tiles Kitchen Tiles Balcony Tiles 4Way Wheel Spanner,Foldable Saw Horse,Spanner Without Heated,5Pcs Scissor Set PERFECTS ENTERPRISE LIMITED , https://www.chibelco.com
Detailed graphics and text: wall tiles and floor tiles posted inspection acceptance process