Ordinary consumer home improvement, choose glass mosaic to pay attention to the following aspects: First, the glass mosaic with stripes and other decoration, the decorative area of ​​the decoration should account for more than 20% of the total area, and the distribution is even. Second, the back of the monolithic glass mosaic should have a jagged or stepped groove so that the paving will be stronger. Thirdly, in addition to ensuring the adhesive strength, the adhesive used should be easily wiped off from the glass mosaic. The adhesive used can not damage the back paper or discolor the glass mosaic. Fourth, under natural light, the height of the mosaic is about 40 cm, and it is visually observed whether there are cracks, defects, missing edges and corners. Fifth, randomly select nine square glass mosaics to form a square, flat in a place with sufficient light, and visually measure whether the gloss is uniform at a distance of 1.5 meters from it. If the gloss is uneven, it will easily fade in the wet bathroom and destroy the appearance of the wall. Paving and installing "four" steps Base surface treatment: Before installation, first ensure that the base surface of the installation surface is flat, and the reserved installation position should be greater than the required mosaic thickness of 3-5MM. A thorough cleaning work should be done before paving. Pre-shop: Before installation, it should be pre-laid according to the construction installation drawing. When the area is large, it will be combined with the numbering diagram. Paving: Apply 2-3MM serrated spatula to the base layer evenly. The thickness is 3-5MM. The monolithic mosaic is aligned to the gap according to the drawing and placed on the combed adhesive. The gap between the two pieces should generally be roughly the same as the gap between the small pieces on each piece. Place the flat planks on the mosaic surface and evenly tap with a rubber mallet to ensure a firm bond. In case of a mosaic that is too high or too high, the granules must be removed to level with a method of reducing or increasing the binder. Caulking: After the moisture is properly dried and has an initial strength, the grout is poured into the mosaic gap with a wooden or rubber spatula. After the filling agent is filled, the moisture is properly dried and the initial strength is used to start the cleaning work. 2 Flutes Spot Drills for Aluminum,HRC58 Spot Drills for Aluminum,Tungsten Carbide Spot Drills for Aluminum Suzhou Meiwei Cutting Tools LTD , https://www.meiweitools.com
Mosaic selection and installation
Jc001.load('iframe') JIFrame.create({ 'url' : '/go.php?action=ads&iframeHeight=250&isIframe=1&key=%BC%D2%BE%DF&pos_id=jc001_news_detail_30&reqkey=1&style=margin%3A15px+15px+ 25px+0%3B+height%3A255px%3Bwidth%3A255px%3B+float%3Aleft%3B', 'height' : 250 })