Pattern wall brick 1. Find the front before the shop The base layer should be cleaned before tiling. If there are lime plaster, latex paint, wallpaper and other decorative objects on the wall, or there are dirt on the ground, it must be cleaned, otherwise the cement mortar will not bond well with the base layer; in addition, if the wall itself If there are cracks, they should be properly treated before they can be tiling, so as to avoid the cracks or falling off of the wall bricks caused by the cracks in the basic structure in the future; and the wall surface of the cement should be napped, for the ground or wall with too much flatness or verticality difference. It is also necessary to use cement mortar for leveling. 2, the laying order is stressful The floor tiles should be affixed from the inside to the outside. If there is slope or floor drain on the ground, you should pay attention to the slope according to the drainage direction; the wall tiles should be laid from the bottom to the top. For the sake of beauty, the bottom brick should be attached. After the wall tiles are finished, press the floor tiles again. When there are half bricks, they should be placed below. In addition, one wall can not be attached to the top at a time, in case the tile has a large weight and causes collapse. 3, wall tiles should be fully soaked Wall tiles have a high moisture content and must be taken into account when pasting. The base layer before tiling should be fully watered and wet, and the tiles should be soaked in water for at least 20 minutes before use. Otherwise, the moisture in the mortar is quickly absorbed by the dried substrate and the tile, which will affect its adhesion fastness. Wall tiles also absorb moisture from the cement, making the cement unable to act as a patch. In addition, the water absorption rate of each brand of wall tiles is also different, which is based on experience. Led SMD down light surface mount have classic aesthetic design close to natural life , so it is very easy to store and install. Led panel lights are consisted of high quality aluminum housing,PC diffuser and LGP,high efficiency reflector,high lumen light chip and the driver for option. The improved diffuser structure creates an even light distribution. Our surface mount flat led panel lights are ideal solution for offices, hotels,hospitals,conference rooms,schools,public facilities or any space where an efficient and reliable fixture is needed.
Clour temperature: 3000K, 4000K,5000K,6000K,6500K
Led Smd Down Light,Smd Downlight,Led Panel Lights,Flat Led Panel Lights WOSEN LIGHTING TECHNOLOGY LIMITED , https://www.wosenled.com
Aluminum housing with anti-fading static powder coating and anti-light leakage
High-performance led chip, energy saving, high light efficiency
Green environmental protection,no ultraviolet,infrared and mercury pollution
Intelligent constant current IC driver
High brightness chip for option
PC/PMMA diffuser and LGP
Isolated or non-isolated driver for option
Lifespan 50000 hours
Light weight
Main points of wall tiles