Home renovation projects are everywhere. To be comfortable and convenient in the future, the range hoods cannot be installed casually. Following Xiaobian together to understand the range hood installation methods and precautions.

1, range hood installation environment:

Range hoods should be installed around the door to avoid too many doors and windows, because too much air convection over the doors and windows, so that soot does not rise to the effective suction range of 250mm has spread a lot, the effect of sucking fumes affected.

2. The range hood should be installed directly above the fume exhaust gas. The height is 650~700mm.

3, range hood exhaust pipe installation requirements:

(1) The distance from the exhaust outlet to the body should not be too long, the turning radius should be as large as possible and there should be less turning, otherwise the effect of smoke exhaustion will be affected.

(2) The exhaust pipe shall extend out into the air or pass into the common suction cold flue duct, and the interface shall be tight, and the waste gas shall not be discharged into the hot flue.

4, the range hood body to maintain the level: After the body is installed, observe the level.

  

1. Drill 3-10 holes on the wall, depth 50-55mm, bury 10 plastic expansion pipes, and then fasten the hooks (accessories) with wood screws.

2. Insert the exhaust hose into the check valve assembly and tighten with a 2-st 2.9x8 self-tapping screw.

3. After the machine is lifted, the two oblong holes in the back wall can be aligned with the hooks, and then the exhaust hose can be led out of the room. Note that the outlet of the exhaust hose should be lower than the indoor.

4. Install a m5x25 screw into the screw hole in the middle of the hanging plate and tighten it to prevent the hood from sliding off. The installation is completed.

  

1, the use of range hoods

Insert the power plug into a three-pin power socket with a grounding device.

(1) In the off state, press the “strong” and “weak” keys to start the hood and run in strong/weak wind conditions. The “strong” and “weak” keys have interlocking functions.

(2) The "Lamp" button is used to control the lamp individually. Press the lamp once and press it again.

(3) In the power-on state, press the “OFF” key to stop the smoke machine under operation.

2, the range hood notes

(1) The exhaust gas from the cooker hood should not be discharged into a hot flue used for the exhaust of fumes from burning combustion gases or other fuels to prevent fires.

(2) The range hood is used when the stove consumes gas or other fuel, and the room must be well ventilated.

(3) It is forbidden to bake cooker hoods directly.

(4) A reliable grounded power outlet must be used.

(5) If the power cord is damaged, it must be replaced with a special cord or a special component purchased from its manufacturer or service department.

(6) If the method is not clearly specified by the bead, there is a risk of fire in the range hood.

(7) When replacing the lamp, please unplug the power first. The power of each lamp is not more than 20W.

(8) When cleaning, wear rubber gloves to prevent metal parts from hurting. Remove the removed parts to avoid deformation.

(9) Special care should be taken when cleaning the wind wheel. It is not allowed to deform or move the weights of the blades. Otherwise, the vibration of the whole machine will increase and the noise will increase.

(10) Do not unplug the power cord for a long time.

In order to maintain the performance of the cooker hood and extend its lifespan, you should always pay attention to daily maintenance. Please unplug the power plug during maintenance to ensure safety.

  

1. Always keep the exterior of the range hood body clean. After use, wipe the shell and grille with a dry cloth or a soft cloth moistened with a neutral detergent.

2. When the oil cup is full of slop oil up to eight minutes, it must be drained to avoid overflowing the polluted environment. The oil cup cannot be soaked and cleaned with strong acid or alkali cleaner.

3, the filter is used for a period of time (usually about twenty days); it will affect the use of the effect due to the attached oil, must be removed for cleaning.

4. It is strictly forbidden to wash the range hood directly with water to prevent the electrical components from entering the water.

5. If the hood is abnormal, it shall immediately cut off the power and suspend use.

The above is about the introduction of the range hood installation instructions, if you want to learn more about the decoration of home knowledge, please pay attention to this site decoration information channel.

Precautions NVC lighting range hood socket window lighting room

Sewage Pump

Sewage Pump,Sewage Pump System,Submersible Sewage Pump,A Basement Sewage Pump

Shanxi Skysea Pump Lndustry Co.,Ltd. , https://www.skyseatianhai.com